Veripart VPSBS177B, User Manual, Page: 67 / 138

67
PROBLEM POSSIBLE CAUSE SOLUTIONS
There is too
much frost and
ice.
- The door is not closed properly.
- The door gasket is deformed or
dirty.
- The products are not packed
correctly.
- The temperature is set incorrectly.
- The appliance is fully loaded and
set to the lowest temperature.
- The set temperature in the
appliance is too low and the
ambient temperature is too high.
- Find the cause of the door not
closing properly, remove or
move possible obstacles.
- As a result, the door does not
close properly. Clean the seal
and repair the deformation.
If necessary, replace the seal,
contact customer service.
- Pack the products better.
- Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
The compressor
works
continuously.
- The temperature is set incorrectly.
- Many products are placed at the
same time.
- The room temperature is too high.
- The food placed in the appliance
was too hot.
- The door is not closed properly.
- Please refer to Section 4.
- Wait a few hours and then
check the temperature again.
- Please refer to Section 4.
- Allow food to cool to room
temperature before storing.
- See the previous section.
The lamp does
not work.
- The lamp is broken.
- The lamp is in the standby
position.
- Please contact our customer
service.
- Close and open the door.
Poor cooling
efficiency
- Do you put hot food or too
much food in the appliance?
- The door does not close
properly.
- Is there direct sunlight or a
stove or heater nearby?
- Is the appliance properly
ventilated?
The temperature set too high?
- Cool hot food before putting
it in the appliance.
- Check the door and door
rubbers and see if the door
is blocked.
- Place the appliance further
away from the heat source.
- Ensure sufficient distance to
ensure proper ventilation.
- Set the appropriate
temperature.
7.1 SWITCHING OFF AND STORAGE
If the appliance will not be used for several months, first switch it off and then
pull the plug out of the socket.
• Make sure the appliance is completely thawed.
• Clean the inside thoroughly and wipe dry. To prevent the formation of
odours and moulds, leave the door open: block it.
• Clean the door gasket groove with soap and water and carefully wipe it
dry.
• Do not use a hard brush, steel brush, detergent, soap powder, alkaline
detergent, benzene, gasoline, acids, hot water or other corrosive or
soluble substances to clean the appliance.
• Store the cleaned appliance in a dry, ventilated place, away from a heat
source. Make sure the appliance is on a level surface and do not place
heavy objects on top.
• The appliance in storage must not be accessible to children playing.
7. TAKING OUT OF SERVICE