Installation
Installation
Connecting Diagram
Plug assignment:
PIN 1
+12 V DC
red
PIN 2
Heat (optional)
green
PIN 3
Not assigned
-
PIN 4
Video output
clear
PIN 5
Audio (optional)
blue
PIN 6
Reversed display
yellow
PIN
7
Ground
shield
•
Connect the video output signal of the camera (PIN 4, clear wire) using a suitable video cable
(insulated coaxial cable, 75 Ohm) to the designated video input of the recorder.
•
The recorder provides service voltage to the attached cameras (12 V DC). Use a suitable cable for
connecting the power supply (PIN 1, red wire) and make sure the connector fits correctly and cleanly
and has the correct polarity. Operate the camera exclusively using the normal service voltage indicated.
•
The standard Back Eye Camera RP105 is designed to show reversed images. The reverse-image display
should be used if the camera is mounted on the vehicle pointing backward. If the reverse-image
display is not used, the PIN 6 (yellow wire) should be connected to ground (PIN 7).
•
Lay the cable from the camera to the recorder (or to the monitor). Lay the cable from the camera
directly into the interior of the vehicle. It is important to ensure that the safety of the driver is not
impaired.
Initial operation
Check to see that the camera provides an acceptable video signal and that the picture section was chosen
correctly. Correct the angle if necessary.
Please never open the dome camera itself. There are no further setting options on the inside of the camera
module.
8
