3.4
CONNECTING THE BATTERY PACK (RC & EFC MODELS)
a)
To prevent un-necessary battery drain, the battery pack that is
used to provide the remote control or trim switch function for this
product is disconnected at the factory. Prior to attempting to light the
product, can the installer please ensure that the battery pack is
re-connected as shown in section b), c) & d) below.
b)
Locate the battery pack in the support cradle at the bottom R/H side of
the firebox / burner assembly.
c)
The wire and connecting plug from the battery pack should then be
connected into the supply wire running from the control board. See Fig
30 below.
Fig. 30
d)
Replace the battery pack into its mounting cradle below the burner.
3.5
FITTING THE TRIM (ALL MODELS)
a)
The trim is held in position on the fixing flange by magnets.
3.6
FITTING THE FENDER (ALL MODELS)
a)
The fender is placed up to the front of the ceramic front rail on
all models. Position the ashpan under the fender and centralise.
Battery
Pack
Connecting Wire
Connecting
Plug
29