Verhagen Leiden V-move EDV, User Manual

Page: 14 / 17

Verhagen Leiden B.V.
|
Hoge Rijndijk 267
|
2314 AG Leiden
|
T: +31 (0)71 581 30 30
|
F: +31 (0)71 541 61 89
13
info@verhagenleiden.nl
|
www.verhagenleiden.nl
7. Maintenance
Follow all instructions as described in this manual, particularly the chapter on safety.
The V-move may only be moved by driving it under its own power or lifting it with a forklift.
Towing will seriously damage the drive.
Maintenance of the V-move must be carried out by qualified personnel, observing the
warnings on the V-move and the instructions for use.
Before disconnecting the batteries, always disconnect any electric loads to avoid possible
sparks. When removing batteries, first disconnect the earth cable (-). When mounting, connect
the earth cable last (connect plus (+ = red) to plus and minus (- = black) to minus).
Battery fluid is a caustic acid. Avoid contact with clothing, skin and eyes.
In the event of splashes of battery acid on clothing or skin, wash with soap and water
immediately, and rinse thoroughly with plenty of water. If any acid splashes in the eyes, rinse
with clean tap water for at least 5 minutes and consult a doctor immediately. Always wear
safety gloves and goggles when performing any maintenance.
7.1 Preventive Maintenance
The V-move has been lubricated, adjusted and test run by your supplier.
Assuming normal use, the following maintenance instructions apply. Maintenance should be carried
out at shorter intervals when used intensively or under extreme conditions.
Item 1X
every
Remarks
Batteries Day Check capacity.
V-move Day Check for visible damage or defects.
Tyres Week Check for any tyre wear
Pictograms Week Check legibility and replace if necessary.
Clean Year See section 6.7.
Maximum speed It should be possible to reach the maximum speed when
accelerating slowly. If this is not the case, please contact Verhagen
Leiden BV.
Lubricating Year Lubricate grease nipples on bearings, drive wheels and steered
wheels.
Bolts, pivot points
and hinge points
6
months
Check that all bolts are still tight and check the pivot points, hinge
points and guides for wear and play.