9
3. Fasten your desktop on the table frame. On the beams holes with an ø6.5 mm
are provided for fixing the desk top (recommended screws ø5.5 to ø6.0 mm).
4. Install the control unit and the handset on the desktop. On the control unit you
have ø5.5 mm holes and at the handset you have ø4.5 mm holes. For the
control unit, you should use screws with a lens or cylinder head.
5. The screws for assembly of the desk top are not included.
Make sure, that the motocables are long enough to connect to the controlbox. If
necessary you can place the controlbox excentric under the tabletop. For very
long tables you can use a motorextension cable.
6. Connect the motorcables form the column to the controlbox.The plug-
connection has to click into place. If a controlbox is used, which has mire plug-
terminals than needed you always have to start to connect to M1 (The
redundand terminals can be left open)
7. Make the connection between the handset and the control unit (HS) and then
plug the power cord into the controller (AC).
Use only the supplied power cable! The control unit “COMPACT“ needs
necessarily a 3-pin power cable with ground wire.
Attach all cables to the table frame or on the underside of the table top so as to
avoid any damage during operation.
