Veratron OceanLink 4.3, User Manual

Page: 25 / 88

SYSTEM SETTINGS
A2C15587600
OPERATING THE SYSTEM CONFIG MENU
NOTE: the underlined value/command is the factory default one.
Setting Description Possible values / commands
Display >
Illumination Brightness of the display.
NOTE: this setup affects all the
EasyLink gauges too.
0–7, Auto
Display >
Bargraph settings Bar graphs minimum and
maximum setup.
• Boost press: 0–13 bar (default = 0–1)
•
Engine temp 0–300 °C (default = 0–200)
•
Battery voltage 8–32 V (default = 10–16)
•
Fuel flow 0–800 l/h (default = 0–150)
Units Unit of measure for the
displayed data.
• Metric
•
Imperial
•
Nautical
•
Custom: completely customizable
Damping >
Wind damping/
Heading damping Damping for wind and heading
displayed data.
•
No
• Low
• Medium
• High
Clock >
Clock format Clock format.
•
12 h
•
24 h
Clock >
Clock offset Time zone setup. From -12h to +12 h (0 h)
EasyLink
Which engine and tanks are to
be displayed on the EasyLink
gauges.
•
Show engine data from: Engine 1–4
•
Show fuel from: Tank 1–4
•
Show fresh water from: Tank 1–4
•
Show waste water from: Tank 1–4
J1939 Gateway Configuration for the SAE
J1939 to NMEA 2000 gateway.
All the data received from the
J1939 bus will be sent on
NMEA 2000 with the instance
specified here. Send to NMEA 2000 As:
•
Auto: the display keeps the J1939 engine
identifier also for the NMEA 2000 network.
•
Engine 1–4
Reset >
Reset factory Reset the display to factory
default.
•
Yes
•
No
Reset >
Reset Trip time
•
Yes
•
No
Reset >
Reset Trip Distance
•
Yes
•
No
Reset >
Reset Trip Fuel
•
Yes
•
No