Verathon BLADDERSCAN BVI 6400, Operation & Maintenance Manual

Page: 20 / 48

14
1. Plug the charging cradle into an electrical wall outlet.
2. Place the device in the charging cradle. The scrolling‑segments battery icon displays, indicating that the
device is charging.
If the battery icon does not appear, then the device was completely discharged. Allow the battery to
charge for 2 hours. If the scrolling‑segments battery icon does not appear after 2 hours, reactivate the
device according to the following procedure.
PROCEdURE 3. ACTIVATE THE dEVICE (OPTIONAL)
Complete this procedure if the battery is completely discharged, or if after 2 hours in the charging cradle the
device does not show the scrolling‑segments battery icon.
1. Using the tip of the activation tool, press the Activation button located just above the Scan button.
2. Place the device in the charging cradle or docking station until the “full battery” icon is displayed.
Note: When you are not using your device, Verathon
®
recommends that you store it in the charging cradle
in order to ensure that your device is always sufficiently charged. The charging cradle cannot overcharge the
battery.
PROCEdURE 4. INSTALL SCAN POINT SOFTWARE (OPTIONAL)
If you are using Scan Point
®
Image Management Technology, install it according to the instructions in the
Scan Point user’s manual. Refer to the manual for further instructions on how to use Scan Point or how
to set up and install the Scan Point label writer. For more information, see the section
Scan Point Image
Management Technology (Optional) .