2
BATTERY & ADAPTER INSTALLATION
Home Receiver Unit:
Main Power Source: Plug in the 6.0V adapter into the adapter socket for basic operation and continuous
backlight.
Backup Power: Open the battery door, install 2 pieces of AA backup batteries according to the polarity indicated.
Close the battery cover.
Remote Sensor:
Loosen the screws on the battery door with a small screwdriver, insert 2 pieces of AAA batteries according to the
polarity indicated. Replace the cover and tighten the screws.
INITIAL SETTING
After powering on the main unit, the weather icons will flash. Press [+] or [
-
] to select local weather condition as
initial setting. Press [CLOCK] to confirm and exit. (Refer “WEATHER FORECAST” section for details).
SETTING UP THE WIRELESS THERMO-HYGROMETER:
For the first installation, always turn on the home unit and then the remote sensor. Set Channel 1 for the first
remote sensor. Set channel 2 and channel 3 for the 2
nd
and 3
rd
sensor.
Press and hold [SEARCH] button for 3 seconds to search for remote unit. The outdoor reading (“----“ or
temperature digits) in the OUTDOOR display mode will flash indicating it is in the searching mode
Press the [Tx] button on the back of remote sensor to transmit RF signal.
When RF connection is established, the respective temperature & humidity of the selected channel will
appear on the OUTDOOR display mode.
WEATHER FORECAST
The unit predicts weather condition of the next 12 – 24 hours based on the change of atmospheric pressure.
The coverage area is around 30 – 50 km. The weather forecast is based on atmospheric pressure change and is
about 70-75% correct. As weather conditions cannot be 100% correctly forecasted, we cannot be responsible
for any loss caused by an incorrect forecast.
SUNNY
PARTLY CLOUDY
CLOUDY
RAINY
STORMY
(Whole graphic is flashing)
To obtain an accurate weather forecast, you need to input your current weather condition as initial setting. After
the powering on the main unit, Press [+] or [
-
] to select the local weather condition as initial weather forecast
setting. Press [CLOCK] to confirm and exit.
