SERVICE
Service - 35
15. Remove the rear cab mounts from the power
unit roll bar and store with the cab.
16. Loosen the 1/2” bolts that fasten the front cab
supports to the front cab mounts, but do not
remove. Remove the front cab mounts from the
power unit foot platform and store with the cab.
17.
Remove the pump cover with flanges from the
power unit center column and reinstall the origi-
nal pump cover.
18. Remove the left and right canvas column
mounts from the power unit dash.
19. Remove the left, right, and top window brackets
from the rear of the power unit.
20. Move the power unit steering cylinder to the mid-
dle mounting hole if using dual wheels or move
to the inner hole for use with single wheels.
21. Reinstall the right and left foot pegs, if desired.
22. The 4-point seat belt may be left installed for use
without the weather cab. If the 4-point seatbelt
is removed from the power unit, the original lap
belt must be reinstalled.
23. Place all cab components that were removed
from the cab and power unit on the pallet inside
the weather cab.
24. Reinstall the right emergency window and the
right and left rear windows onto the cab.
25. Place the door inside the cab for storage, or
remove the lower door window, the window
support, and the lower door support bracket and
place inside the cab and reinstall upper door
onto the cab.
26. Secure the cab to the pallet and store at a loca-
tion where it is unlikely to get damaged.
Removing the Weather Cab from Storage
I
nspect, clean, and install the weather cab accord-
ing to the setup instructions in this manual.
Summary of Contents for KW450
Page 3: ...Blank Page ...
