WEATHER CAB SETUP INSTRUCTIONS
Setup - 25
60. Align the gas
door shock end
with the mount-
ing stud on the
cab frame and
press until
shock end
snaps over the
head of the
mounting stud.
61.
The gas door shock must be installed to prevent
the door from opening too far or swinging open or
shut too fast.
Damage to the door glass and/or weather cab
glass may occur if gas door shock is not installed.
Install the right lower window and right lower
window bracket. Remove the nuts from the 4)
step bolts installed
1
2
4
3
AA
in the window. Do
not remove the
spacers. Insert the
bolts into the 3)
mounting tabs (1,
2, & 3) on the cab
frame. Install the
right lower window
bracket (AA) on
the 3) rear step
bolts (2, 3, & 4)
and fasten all four
places with 1/4”
flange nuts.
Tighten only until
rubber washer
under the step bolt head begins to bulge slightly.
BB
62. Install the lower
door window
support to the
door frame with
2) 5/16 x 3/4”
bolts (BB) and
5/16” flat wash
-
ers. Fasten
with 2) 5/16”
locking flange
nuts. Tighten
until snug but
support can still
be moved.
63. Install the lower door
2
3
4
1
DD
CC
window and the
lower door window
bracket (DD).
Remove the nuts
from the 4) step
bolts installed in the
window. Do not
remove the spacers.
Insert the bolts into
the two mounting
tabs (1 & 2) on the
door frame and the
mounting hole (3) on
the lower door
window support (CC).
Install a 1/4” flange
nut on the top front
bolt (1) to hold the
window in place.
Install the lower door
window bracket (DD) on the 3) rear step bolts and
fasten with 1/4” flange nuts. Tighten all four flange
nuts only until rubber washer under the step bolt
head begins to bulge slightly.
64. Shut the cab door and check the seal of the lower
window to the power unit and weather cab. Move
the bottom of the lower door window support in or
out until window seals properly.
2
1
3
FF
EE
2
1
3
Tighten the 5/16 x
3/4” bolts at the top of the lower door window
support. Note: If door latch adjustment is required,
refer to the service
section of this manual.
65. Install the left column
canvas (EE) onto the
left side of the front
frame column. Fasten
the Velcro to the dash
panel (1), the frame
plate (2), and the
flange on the pump
cover (3).
66. Install the right col-
umn canvas (FF) onto
the right side of the
front frame column.
Fasten the Velcro
to the parking brake
cover (1 & 2), and the
flange on the pump
cover (3).
Summary of Contents for KW450
Page 3: ...Blank Page ...