Service - 36
C
HANGING
THE
H
EADLIGHT
B
ULB
AVOID PERSONAL INJURY!
The headlight bulb contains gases under pres-
sure. The bulb may shatter if the glass is
scratched or dropped. Wear eye protection and
handle bulb with care.
1. Park power unit on a level surface.
2. Engage parking brake and shut off engine.
3. Remove ignition key from switch.
4. Remove the two screws clamping the headlight
cover on (A) and remove cover.
5.
A
A
A
A
Disconnect ground wire from the defective head-
light (B).
6. Remove wire loom and shrink wrap from positive
wire (C) and disconnect the positive wire.
7. Remove the defective light bulb from the light as-
sembly by pinching the wire spring fastener.
8. Install the new light bulb and secure with spring
fastener (D).
9.
B
C
D
Place heat shrink tubing over the positive wire.
10. Reconnect the positive and negative wires as
removed.
11. Slide the heat shrink tubing over the connector,
apply heat to shrink, and replace the wire loom.
12. Reinstall the headlight cover.
C
HANGING
THE
T
AILLIGHTS
1. Park power unit on a level surface.
2. Engage parking brake and shut off engine.
3. Remove ignition key from switch.
A
A
B
B
4. Remove the tail-
light cover (A).
5. Pull the old
bulb (B) from
its socket.
6. Apply dielectric
grease and in-
stall new bulb.
7. Snap taillight
cover back into place.
C
HANGING
THE
F
USES
A
A
B
B
D
D
C
C
E
E
F
F
R
EF
C
IRCUIT
F
USE
S
IZE
A
Headlights, Taillights, Tach. Light
15
B
Gauges, Signal Lights
5
C
Rear Auxiliary
15
D
Engine Supply
15
E
Fuel Pump
5
F
Start and PTO Circuits
15
1. Park power unit on a level surface.
2. Engage parking brake and shut off engine.
3. Remove ignition key from switch.
4. Open engine hood.
5. Identify and pull the defective fuse from socket.
6. Push new fuse into socket. Be certain to use the
correct size fuse, or damage may occur to the
power unit.
7. Close engine hood.
SERVICE
