Venta AH510, Instructions For Use Manual

Page: 33 / 344

EN 33
CLEANING OF
THE UPPER HOUSING
Caution! Ensure the appliance is switched off during all actions and the
switching power supply is disconnected from the power outlet!
01 Detach upper housing from lower housing. Press locking buttons so
that the ends stand up.
02 Fold side parts out of the way.
03 Fold ribbed wings out of the way.
04 Unplug the switching power supply from the drive unit
1
. Lift the drive
unit upwards and out
2
. Disconnect the switching power supply cable
by releasing the bracket
3
and pull downward and out through the
opening of the upper housing
4
.
!
∙
Do not disassemble the drive unit and the switching power
supply, immerse them in water or bring them into contact with
liquids!
∙
Only clean the drive unit with fan blades and gear with a dry
cloth!
∙
The disassembled upper housing can be cleaned under run-
ning water!
∙
The disassembled upper housing must be absolutely dry be-
fore assembly!
05 Insert the drive unit into the upper housing from the correct side
1
. Pull
the switching power supply from the bottom upwards and through the
opening of the upper housing
2
and plug it into the drive unit until it
clicks into place
3
. Affix the cable with the bracket
4
.
06 The outer ends of the locking buttons must be standing up. Fold the
ribbed side wings
1
and
2
upwards, then the side elements
3 a
nd
4
. Close the upper housing correctly by pressing down on the outer ends
of the locking latches
5
and
6
.
!