3
Installation and Wiring Instructions for the
Lo-Carbon PoziDry Pro Positive Ventilation Unit.
SAFETY AND GUIDANCE NOTES
IMPORTANT:
READ THESE INSTRUCTIONS BEFORE COMMENCING THE INSTALLATION
1.
DO NOT install this product in areas where the following may be present or occur:
1.1. Excessive oil or a grease laden atmosphere.
1.2. Corrosive or flammable gases, liquids or vapours.
1.3. Ambient temperatures higher than 40°C or less than -5°C.
1.4. Possible obstructions which would hinder access or removal of the Fan.
1.5. Relative humidity above 90%
1.6. Sudden ductwork bends or transformations close to the Unit.
2.
All wiring to be in accordance with the current I.E.E. Regulations, or the appropriate
standards of your country and MUST be installed by a suitably qualified person.
3.
The fan must be provided with an isolator switch capable of disconnecting all poles,
having a contact separation of at least 3mm.
4.
Ensure that the mains supply (voltage, frequency, and phase) complies with the fan’s
rating label.
5.
The fan should not be used where it is liable to be subjected to direct water spray.
6.
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
7.
Precautions must be taken to avoid the back-flow of gases into the room from the
open flue of gas or other fuel-burning appliances.
8.
Children of less than 3 years should be kept away unless continuously supervised.
9.
Children aged from 3 to 8 years shall only switch on/off the appliance provided the
unit is installed as intended for normal operation and they have been given
supervision or instruction concerning safe use of the appliance and understand the
hazards involved.
10. Children aged 3 to 8 shall not plug in, regulate and clean the appliance or perform
user maintenance
Caution - some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are
present.
A. INTRODUCTORY NOTES
The Vent Axia Lo-Carbon PoziDry Pro is a positive input ventilation unit, designed to be installed in the loft of a
dwelling to continually supply filtered fresh air into the building. The system consists of a fan unit, a heater unit (for
heater models) and a diffuser (for diffuser models) with a short length of flexible ducting.
The Lo-Carbon PoziDry Pro has two fully adjustable speed settings; ‘Trickle’ and Energy recovery’. These speeds
are set during installation; there are 5 pre-set speeds or an option allowing the speeds to be chosen manually from
10L/s to 60L/s. The Lo-Carbon PoziDry Pro uses a sensor to monitor the temperature in the loft, automatically
adjusting the air volume when necessary.
•
The fan will run in ‘Trickle’ speed when the ambient loft temperature is less than 18°C.
