7
8
Insert the screw head into the embossed key hole.
Push the chassis to the wall and insert the screws into the slots.
Tighten the screws so the hood is firmly attached to the
cupboard.
Insert the fifth screw in the centre of the chassis.
Caution:
The electrical connection must comply with regional
electrical codes. The appliance must be grounded.
a- The ground lead must be attached to the connector
installed on the range hood chassis.
b- The white lead must be connected with the white lead of the
power supply (neutral).
c- The black lead must be connected with the black lead of
the power supply (live).
It is recommended to use insulated wire connectors.
Make sure the damper of the adaptor opens freely.
Install the five screws of the bottom cover using the four
additionnal screws available in the installation bag.
Put the filters back in place.
5
INSTALLATION OF THE CHARCOAL UNIT
VENMAR
1
2
3
F
1 ¥ 2 ¥ 3 ¥ O
0 ¥ 5 min.
VENTILATION in
c.
4
5
6
7
1
3
2
8
9
10
Warning:
The heating element of the range and the underside of the hood must
be, at least 20” (50 cm) apart. Over a gas range, the distance must be
increased to, at least, 24” (60 cm).
Install the neoprene gasket on the charcoal unit.
If the bottom of the cupboard is recessed, attach two wood strips
as shown to be able to screw the range hood under the cabinet.
Position the 4 screws according to the holes on the charcoal unit.
Do not tighten the screws down so the hood can be placed on
them before tightening.
Insert the screw head into the key hole.
Push the charcoal unit to the wall and insert the screws into the
slots.
1
2
3
4
5
6
11
12
13
14
15
16
