Clean Up and Tips
·
When you have finished using the tape dispenser, remove the bottle from the mount
(while keeping the hose attached) and hold it below the water basin. Gently squeeze
the bottle a few times to vacuum the basin water back into the bottle. To remove all
water from the basin, tilt the dispenser on its side to direct the water toward the filling
port.
_
·
Lightly moisten the end of the veneer tape. Loop it back over the aluminum pin and
stick it onto the roll as shown below. Doing so will keep the tape from sticking to the
wetting wheel until it is ready to be used during your next veneering project.
_
·
Optionally, the wetting wheel can be removed and dried with paper towels.
·
Increase the rate of wetting by pulling the tape slowly. If you prefer even more
wetting, pull slower and place gentle finger pressure on the tape over the wetting
wheel.
Maintenance
·
A few drops of bleach mixed into the water supply will help prevent mold from
forming on the wetting wheel.
_
·
The tape cutter is made from spring steel and should be sprayed with silicone or
machine oil as needed to prevent corrosion.