5
REMOVE DOOR
1.A)
Unplug machine from power
outlet to prevent electrical shock.
1.D)
Remove coin return motor and
bracket from OEM door and set
aside for re-use.
1.A)
Locate new controller UNIVERSAL CONTROLLER
(VE5801M
), and
MERCHANT CONTROLLER (
VE1017151
) in kit and install STANDOFF
(
VE1017112
). Once standoffs are installed , remove the ends of the bottom
two standoffs as shown in the picture. This will decrease the pressure on
the board as harnesses are installed.
1.B)
Mark the tray connectors or wires
going to the controller in such a way
to identify them for re-assembly with
the new controller. Tray 1 connector
is located at the top.
1.E)
Remove fasteners that hold the
slides to the door, then remove door.
Do not remove the OEM slides from
the cabinet. They will be used to
mount the new door.
1.B)
Mount new controller in cabinet,
then secure with the OEM screws you
removed earlier.
1.C)
Unplug all harnesses from the
controller.
1.F)
Remove OEM controller from
cabinet and retain all screws and
standoffs.
ATT
A
CH HARNESSES
INS
TALL DROP SENSOR
REMO
VE DOOR
INS
TALL DOOR
STEP 1. New Controller
INSTALL NEW DOOR
REMOVE DOOR
WARNING
To prevent personal injury and equipment damage, turn machine off and disconnect electrical cord from the wall
outlet before installing door. Failure to do so could result in electrical shock.
!!
VE1021148 - Media Panel Installation Manual
www.veii.com
TRAY1
TRAY1