Instructions for the installer, maintenance
technician and final user
24
© SandenVendo Europe SpA
3.6 Connection to Power Mains
SERVICE CORD INSTALLATION
CAUTION: BEFORE DOING ELECTRICL CONNECTION CHECK THE
FOLLOWING
:
Assure
that the characteristics of the poer supply (voltage and frequency)
correspond to those indicated on the plate with technical details of the machine:
this vendor must be connected to a 230 V, 50 Hz. power main, voltage under
207 V or over 253 V could cause failures
Assure
that, the supply outlet is grounded and that, after making connection the
entire appliance is ground connected.
Assure
that the appliance is positioned in the way that the plug for main power is
accessible after installation
Assure
that the neutral wire is blue, otherwise invert the poles
CAUTION:
If defects or damages are found on the supply cable it must be
replaced. To protect personnel and prevent any risks of damages to the
machine do not try to subsitute the cable, contact the manufacturer or
technical assistance service.
CAUTION: DO NOT ABSOLUTELY USE EXTENSION CORDS
1) Unscrew the 2 screws in FIG.1
2) Pull out the service cord until the
fastening plate appears as in FIG.2
3) Fasten the plate with the 2
screws as in FIG.3
FIG.1
FIG.2
FIG.3
