3 6 0 5
• 3 6 0 6
16
4 2 2 5 1 3 3 R e v C
INSTALLING A COIN CHANGER
1.
Mount the changer unit onto the 3 screws provided and then secure, See Fig 19.
2.
Check the alignment between the underside of coin entry chute and top of entry hopper,
adjust chute so there is only 1/8” (3mm) clearance.
3.
With the machine switched ON press the coin return button to check the operation of the
coin return. Ensure that the reject lever on the coin mechanism is actuated sufficiently by
the motor cam to clear bent coins, adjust by slackening the screws securing the coin return
motor bracket and adjusting up/down; retighten the screws when complete.
4.
The Coin Changer must be loaded with some coins in each tube for the vendor to operate
properly and allow the bill validator to accept most bill denominations, a minimum of 50% is
recommended.
5.
To fill the coin tube first press the Service Mode button on the control board, then there will
be no restriction on the amount of coins that can be accepted. When exiting service mode
any credit is cleared to zero.
CASH BOX
To remove the cash box lift it vertically upwards to release the shouldered bushes from the keyhole
mounting slots at the back of the box, then pull forward to release, see Fig 20. When returning the
cash box align the shouldered bushes with the keyholes in the rear mounting plate pushed and allow
the cash box to sit down.
IMPORTANT:
1.
Ensure that the cash box is in position before closing the pull-out door
Fig 19. Payment Systems
Fig 20. Cash Box
