3 6 0 5
• 3 6 0 6
15
4 2 2 5 1 3 3 R e v C
SERVICE MODE
Use the Service Mode to program and service the vendor. Use the keypad as an input device. Observe the display for information
while in Service Mode.
SERVICE MODE BUTTON
To enter Service Mode, press the Service Mode Button once, it is
located in the bottom left hand corner of the control board, see Fig 18.
To exit Service Mode, press the Service Mode Button again once or press
the * key 3 times.
NOTE:
If no key is pressed for approximately one minute while in
Service Mode, the controller will automatically return to Sales Mode.
For all programming features and functions please refer to the
4225134 Programming Manual which can be found and/or
downloaded from
http://www.vendnetusa.com/Manuals/Snack
.
MOTOR PAIRING
The ‘motor pairing’ feature facilitates the ganging together of 2 individual motors, so that when a single selection code is entered
both motors will operate together; the LH motor will rotate CCW and the RH motor will rotate CW, the corresponding spirals also
have to be CCW & CW.
This feature allows the 2 motors to be spread apart from each other to suit the width of the item to be vended. The selection width
can be as little as 5 ¾“ (14.6cm) or the paired motors/spirals can span the entire width of the shelf e.g. ganging selection motors
40 & 49.
The 2 ‘paired motors’ have to be wired to suit the physical span between them, this will determine the selection numbers to be
paired.
See the 4225134 Programming Manual for instructions to set-up ‘paired motors’.
Fig 18. Service Mode Button
POWER
