VENDAPIN DATATRON III SERIES 5882, Operator'S Manual

Page: 38 / 48

Copier problems
There are no timing parameters in the Datatron III Print/Datatron III to synchronize with the
timing of the copier. The interconnect instructions for your particular machine came with the
interface cable you ordered. Be sure to carefully check wiring before applying power to prevent
damage.
N
ote:
•
Please ensure that you tested the copy vend using various paper sizes and copies on copier
to verify that all functions are operating correctly, BEFORE you install the Datatron III or
its wiring harness.
•
Be sure that the correct selection of steering or standard mode is selected by the internal
firmware in your Datatron III unit.
Problem Cause Solution
Only one price charged.
Datatron III unit is ‘standard’, but
your copier is ‘steering’ mode. Obtain the correct Datatron
III firmware.
Only one price charged. Perhaps
free copies on Price-2. Datatron III unit is ‘steering’ but
your copier is ‘standard’ mode. Obtain the correct Datatron
III firmware.
If your copier does not operate at all, after it has been successfully in service with
the Datatron III:
•
Unplug the machine-specific harness 9-pin AMP connector, and attach the white 9-pin test
plug jumper in place of the Datatron III. We provide this test connector so you can
efficiently track down problems.
•
If your copier runs, check the Datatron III’s settings and connections described in
Troubleshooting. Contact VENDAPIN support for help.
•
If your copier does not run, the copier has failed. The test plug jumper eliminates the
external control signal enable functions from the copier, and should restore it to its original
operation. Repair the copier.