3
Installation
1. Put the in wall switch into a wall box and connect the AC power wire L,N to
DS-100 connector L, N.
2. Connect the wall switch to the DS-100 as Fig1 .
3. To manually turn ON the Switch, press and release the On/Off button. The
LED will light ON for 1 second, and the load plugged into the Switch will
also turn ON.
4. To manually turn OFF the Switch, simply press and release the On/Off
button. The LED will light ON for 1 second and the load plugged into the
Switch will turn OFF.
Programming
1. Basic Command Class / Binary Switch Command Class
The Switch will respond to BASIC and BINARY SWITCH commands that
are part of the Z-Wave system.
1-1 BASIC_GET / BINARY_SWITCH_GET
Since the switch have two relay, the Switch will report its On/Off state to
the Controller by setting Configuration parameter 3.
Configuration parameter 3=1 Report ON when relay 1 ON
Report OFF when relay 1 OFF
Configuration parameter 3=2 Report ON when relay 2 ON
Report OFF when relay 2 OFF
Configuration parameter 3=3 (default)
Report ON when either relay 1 ON or relay 2 ON
Report OFF when both relay 1 and relay 2 OFF
Basic Get Command: [Command Class Basic, Basic Get]
Basic Report Command:
Report OFF: [Command Class Basic, Basic Report, Value = 0(0x00)]
Report ON:[Command Class Basic, Basic Report, Value = 255(0xFF)]
Binary Switch Get Command:[Command Class Switch Binary, Switch
Binary Get]
Binary Switch Report Command:
Report OFF:[Command Class Switch Binary, Switch Binary Report,
Value =0(0x00)]
Report ON:[Command Class Switch Binary, Switch Binary Report, Value
= 255(0xFF)]
1-2 BASIC_SET / SWITCH_BINARY_SET
Since the switch has two relay, the load attached to the Switch will turn on
or off upon receipt of the following commands from a Z-Wave Controller by
setting Configuration parameter 3.
Configuration parameter 3=1 switch ON and OFF of relay 1
Configuration parameter 3=2 switch ON and OFF of relay 2
Configuration parameter 3=3(default)
switch ON and OFF both relay 1 and relay 2
[Command Class Basic, Basic Set, Value = 1~99, 255(0xFF)]: the load
attached to the Switch turns on.
