Mod.
RX1-8A
Dimensions
Connection diagram
35.6
87.8
60
55
45
4
2
1
5
6
8
7
23
0 V~
50 - 60 Hz
8A / 250V CA
3
Out
Connection examples
M
L
N
NA
C
NC
Out
L
N
NA
C
NC
Out
LOAD
Circulation pumps,
burners, solenoid valves.
Motor-operated valves.
User Manual
REMOTE ACTUATOR MODEL RX1-8A
Read all the instructions carefully
The remote actuator
RX1-8A
is an independently mounted automatic control for
heating and air conditioning applications, designed for radio comunications with
Athena
programmable thermostat and
Klio
digital thermostat
.
It provides a type 1B actions and it is designed for household and similar use with
overvoltage category III (EN 61010-1) and normal pollution level (EN 60730-1).
SAFETY WARNINGS
During product installation and operation, the following safety instructions
should be respected:
1) The appliance should only be installed by technical person support
2) Take out power supply during product installation
3) Do not power or connect the instrument if any part of it is damaged
4) Follow the connection diagrams descripted on this manual and over the
product
Code
Model
Description
VE015400
RX1-8A
Remote actuator
CARACTÉRISTIQUES TECHNIQUES
• Power supply: 230 VAC (-15%/+10%) 50/60 Hz
• Outputs:
- 1 relay 8A 250 V AC (resistive load)
- external antenna (on request)
• Operating temperature: 0°C ÷ 50°C
• Storage temperature: -10°C ÷ 65°C
• DIN-rail mounting
• Protection degree: IP40
USE
DISPLAY AND CONTROLS
1 – Green LED operation function
2 – Red LED relay function
3 – Reset and programmation SET BUTTON
OPERATION
• In starting phase, the red LED flasheses twice for
some seconds (switching on- sequence).
• At the end of the switching on-sequence, the
green LED signal normal device operation and
the red LED relay status (light on = relay ON).
• The remote control (relay commutation ON/
OFF) request from
Klio
digital thermostat and
Athena
programmable thermostat take place
only after channel setting-up.
• The radio connection break down for more than
15 minutes between the transmitter and the
receiver disconnects the relay and the red LED
lightened. Restore of operations is automatic.
Channel setting-up
° During normal operation, press the SET key-button for almost three seconds to enter
in modality-configuration. Green LED switch-off, red LED flash.
° The appliance keep on modality-configuration for a maximum of 60 seconds within
the actuator should receive a string configuration (see Athena and/or Klio instructions
for string start-up modality).
° On receipt of string, channel is setted-up and the actuator is on standard functioning.
° For re-setting up, repeating the procedure.
• To reset channel setting-up, plug into configuration modality with SET button, then push
the same one for three seconds and wait for green led switching on. A new channel setting
up cancels the previous configuration.
STANDARDS REFERENCE
Conformity with EU Directives:
2006/95/EC
(Low Voltage)
2004/108/EC
(E.M.C.)
is declared with reference to the following standards:
Safety:
EN 60730-1
Electromagnetic compatibility:
EN 301 489-1/3 and EN 300 220-3
1
3
2
CLOSE
OPEN
V3IS00378-010-102009
