VEMCO - VR2 Manual
8
3.3
Connect to VR2
Open the VUE software and open a database. The software can be setup to
automatically open the last database used with the software on this computer
(see section 7.1.4).
Connect the VRPC Interface box to the serial port on the computer and make note of the serial port number.
Insert the VR PC Interface probe into the large hole in the VR2 as shown in the photo on the right below.
Open the Home tab in the VUE software and select the correct COM (serial) port
number in the Serial Devices section of the window (see picture at right). A list of
receiver types will appear; select
VR2 (original)
from the list and wait for
communication to be established. The red status lights on the VRPC interface box
verify that communication is being established.
The Receiver Controller Window (RCW) will open and, after communicating with the VR2, list the status of
the receiver.
Continue to the next window (shown below) to verify that the PC time is correct. If the time shown in the
window is not correct, use the “Set Clock” button and change the time, date, and time zone so they are
correctly set to your local time.
A database must be open
for VUE to communicate
with a VR2.
VR PC Interface with probe
Inserting probe in VR2