14
HOW TO USE THE BICYCLE COMPUTER
1.Reset previous values to zero before each
FIG.O
SET+MODE
2S
MODE for changing
from low to high
MODE for changing
from hour to minute
KM/H
MODE
MODE
MODE
MODE
KM/H
2074
KM/H
SPD
KM/H
KM/H
Set speed unit
Set circumference
12Hr/24Hr
Set clock
4.Do the same as above, press SET to select
value and press MODE to confirm and proceed
to next. (FIG.O)
Note:
The bike c ircumference unit is mm.
When in 12H format, P M is displayed
measurement. When the speed is zero (except
SCAN mode), hold SET for 2 seconds to reset the
value of DST(distance), RTM (riding time),
AVS (average speed), RES (relative speed) and
MXS(max. speed)
2.The measurement begins once riding on the
bicycle. If the computer receive no signal during
riding, the " " in the display will not flash. Stop
riding and check if the magnet is positioned
3.Press MODE to select the preferred display or select the
SCAN mode. When in SCAN mode the display will
change between all functions every 4 seconds.
4.The computer will turn off automatically if there is
no operation or signal for 8 minutes, the data for the
jouney will be saved. You can press any button to
turn on the computer to receive the signal again.
H O W T O W E A R T H E C H E S T B E LT
(F O R MO DE L V S-204A /VS -212A )
1.Wet the conductive pads on the underside of
the transmitter with water or conductive gel to
15
When the computer has been installed and the wheel
size has been programmed into the computer, you are
ready to use the cycle computer:
correctly
for afternoon.
In order to get correct heart rate signals, you need to ensure
that the chest belt is worn correctly. (FIG.O) The chest belt
will transmit the data wirelessly to the cycle computer.
