First setup
Connect the receiver with the supplied power supply: position the bare wires into the power input
terminal
(12)
on the board. The black (GND) wire goes into the
“
-
“ terminal
, the red (+12VDC) wire goes
into the “+” terminal
. Use a flat screwdriver to tighten the screws of the terminals.
If the power supply is successfully connected, the Power LED
(5)
will light up and the TUYA LED
(6)
will
start flashing after a few seconds.
Please do not connect the CH1 RELAY and CH2 RELAY terminals
(10 & 11)
or close the enclosure yet. We
first need to pair a transmitter or connect to the TUYA IoT cloud.
Pairing a transmitter to the receiver
1.
Power off the receiver by disconnecting the power.
2.
Make sure there are no connections to the receiver on CH1 RELAY
(10)
or CH2 RELAY
(11)
.
3.
Power on the receiver by connecting the power.
4.
Hold the SETUP button
(9)
on the receiver for at least 3 seconds until the CH2 LED
(8)
will turn on.
5.
Press the CH1 button
(2)
on the transmitter for 3 seconds until the CH2 LED
(8)
will turn off and the
CH1 LED
(7)
will turn on.
6.
The remote is now paired.
You can pair multiple transmitters with a single receiver. Keep following these steps for every transmitter
you want to pair.
Connecting the receiver to the TUYA IoT cloud (optional)
1.
Install the TUYA App or SmartLife app on your smartphone and create a TUYA account.
2.
Make sure there is a stable Wi-Fi connection with internet access present where the receiver is
installed. You will need the Wi-Fi password in step 8, so start looking for it now.
3.
Power off the receiver by disconnecting the power.
4.
Make sure there are no connections to the receiver on CH1 RELAY
(10)
or CH2 RELAY
(11)
.
5.
Push the SETUP button
(9)
and hold it while connecting the power supply.
6.
Release the SETUP button
(9)
after the CH1 LED
(7)
is activated, the SETUP button
(9)
can now be
used for TUYA pairing.
7.
Open the TUYA app or SmartLife app
and add device “Power Strip(Wi
-
Fi)”
.
8.
Follow the instructions in the app
. If the app asks to press the “reset” button, use the SETUP button
(9).
The TUYA LED
(6)
should start blinking rapidly when in pairing mode.
9.
If the device is successfully paired with the TUYA IoT cloud, the TUYA LED
(6)
will be turned on
permanently. From now on, this TUYA LED
(6)
will display if there is an active cloud connection.
10.
Please disconnect the power to the receiver, wait 3 seconds and reconnect the power. The device
will boot in normal operation and you are ready to use it. It will automatically connect to the cloud.
Connecting the receiver with the TUYA IoT cloud is optional. If not connected to the cloud, the
functionality of the VM130V2set will be limited to ON/OFF functions for both channels with the
transmitter.
Summary of Contents for VM130V2SET
Page 1: ...VM130V2SET...
