12
OPERATION
Operating the remote control
: (right hand button if there are 2)
1. Press the button once = alarm activate/deactivate with beep signal.
2. Keep the button pressed in = alarm activate/deactivate without beep signal. (If
there is interference from incident light it is possible that with the IR remote
control will not work).
3. Press again within 5 seconds of the alarm being activated = warning sensor(s)
switched out (a beep will be heard as confirmation).
*
NOTE:
•
Five seconds must be waited between switching the alarm IN and switching it OUT.
•
The alarm only becomes active after 5 seconds of being switched on.
•
If the alarm is to be switched out while the siren is sounding, then it is best to keep
button pressed down on the remote control transmitter unit.
Operation of the dashboard LED:
•
Out: alarm out
•
Slow flash: alarm on.
•
Rapid flash: automatic reset of alarm after switching alarm out, ie there are 60
seconds available to get in and/or start ignition.
Audio and visual signals:
2 x flashes and sound: = alarm on
1 x flash and sound: = alarm off
4 x flashes and sound: alarm off and has been triggered
OVERVIEW OF OPERATION AND INDICATORS
Function activate
deactivate
warning
sensor
warning
sensor x2
direct sensor
Dashboard
LED
Flashing Rapid
flash
Interior siren
2 x beep
1 or 4 x beep
1 x beep
on
on
Hazard
lights
2 x flash
1 or 4 x
flash
1 x flash
flash
flash
Start
not possible
possible
not possible
not possible
not
possible
Siren/
Pager
off
off short
on on
on
Central
locking
locked open locked locked locked
K4400
module
off off on off off
Diagnostic function
:
