VDP301RL
1 VELLEMAN
VDP301RL – 30mW ROCKET RED LASER LIGHT EFFECT
1. Introduction & Features
Thank you for buying the
VDP301RL
! Please read the manual thoroughly before bringing this device into service.
Make sure that the device was not damaged in transit. If the device is damaged, you should contact your dealer and
postpone installation of this device.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
•
A qualified technician should install and service this device.
•
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
•
This device falls under protection class I. It is therefore essential that the device be earthed. Have a qualified
person carry out the electric connection.
•
Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
•
Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
•
Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
•
There may be some smoke or a particular smell when the device is activated for the first time. This is normal and
any smoke or smell will gradually disappear.
•
Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
•
Note that damage caused by user modifications to the device are not covered by the warranty.
•
Keep the device away from children and unauthorised users.
3. General Guidelines
•
This device is designed for professional use on stage, in discos, theatres, etc. The
VDP301RL
should only be
used indoors with an alternating current of max. 230V AC/50Hz.
•
Laser effects are not designed for permanent operation: regular operation breaks will prolong their lives.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device is protected against extreme heat (see “
7. Technical Specifications
”, p.3), dust
and moisture. Respect a minimum distance of 0.5m between the device’s light output and any illuminated surface.
•
Use an appropriate safety cable to fix the device (e.g.
VDLSC7
or
VDLSC8
).
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
•
Use the original packaging if the device is to be transported.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
