GASIRON2
V. 03
–
29/11/2022
5
©Velleman Group nv
6.
Use
Soldering iron
:
●
Make sure the exhaust vent faces up.
●
Set the
on/off switch to the ON position to let the gas flow.
●
Pull the
soldering head forward until you can see the nozzle through the
ignition vent. Then, light the gas by bringing an open flame to the
ignition vent.
●
Release the soldering head. The flame will
disappear inside the head and will generate heat there.
●
Set the
on-off switch to OFF to extinguish the soldering iron.
G
as torch
:
●
Remove the soldering head.
●
Set the on-off switch
to ON to let the gas flow and bring an open flame next to the
nozzle.
●
Set the on-off switch to OFF to extinguish the soldering
iron.
Hot blower
:
●
Screw the soldering tip off the soldering head by
turning it counterclockwise. Ignition and extinguishing are the
same as for the soldering iron.
Flame/heat adjustment
:
●
Adjust the gas flow by means of the
gas volume control. Rotate it to the + or the - to increase or
decrease the gas flow.
Refilling the gas tank
:
●
Make sure the on-off switch is set to
OFF and the GASIRON2 has cooled down completely.
●
Refill the
device in a well-ventilated area away from any ignition source and
away from other people. Do not smoke while refilling the gas torch.
●
Refill with butane gas only.
●
Hold the GASIRON2 upside down,
insert the nozzle of the butane canister into the gas refill valve and
press the canister down to let the gas flow from the canister into
the gas tank of the soldering iron.
●
When the gas stops flowing,
pull the canister out of the refill valve.
7.
Technical Specifications
autonomy .............................................. 40 min. (average use)
temperature .............................................................
≤
450 °C
spare bit ......................................................... GASIRON2/SPB