CS300
VELLEMAN
8
-
Handle the detector gently and carefully. Dropping it can damage circuit boards and cases and
can cause the detector to work improperly.
-
Use the detector only in normal temperature environments. Temperature extremes can shorten
the life of electronic devices, or damage the detector’s exterior.
-
Keep the detector away from dust and dirt, which can cause premature wear of parts.
-
Wipe the detector with a damp cloth occasionally to keep it looking new. Do not use harsh
chemicals, cleaning solvents or strong detergents to clean the detector.
6. Troubleshooting
•
The detector is emitting false signals.
The detector’s sensitivity may be set too high. Try cutting back the sensitivity slightly until the false signal
disappears. Remember to sweep the detector slowly. Some false signals will occur on highly rusted metals,
but if the signal does not appear over the same area while sweeping over it again, then the target is usually
not worth further hunting.
•
The LCD readout is not locking or ID’ing while sweeping over the target. There is more than one tone
being emitted over the same target.
This will usually occur with the presence of more than one object. Objects of a metal unknown to the detector
will not be signalled. Sometimes, oxidation can also make the ID arrows and tones jump around. Try cutting
back the sensitivity slightly if it is set at a high value.
•
Your detector is unstable and emits a pulsing, distorted tone instead of a clear tone.
The presence of interfering signals, such as power lines or another detector nearby, may disturb the
frequencies of your metal detector.
7. Cleaning and Maintenance
Your
CS300
metal detector is an example of superior design and craftsmanship. The following suggestions will help
you take care of your metal detector so you can enjoy it for years.
Modifying or tampering with the detector’s internal parts may cause malfunctions. The search coil is waterproof and
can be submerged in either fresh or salt water. However, do not let water enter the detector’s control housing. Rinse
with fresh water after using the search coil in salt water to prevent corrosion of metal parts.
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
CS300 – METAALDETECTOR MET LCD-SCHERM
1. Inleiding
Aan alle ingezetenen van de Europese Unie
Belangrijke milieu-informatie betreffende dit product
Dit symbool op het toestel of de verpakking geeft aan dat, als het na zijn levenscyclus wordt weggeworpen,
dit toestel schade kan toebrengen aan het milieu.
Gooi dit toestel (en eventuele batterijen) niet bij het gewone huishoudelijke afval; het moet bij een
gespecialiseerd bedrijf terechtkomen voor recyclage.
U moet dit toestel naar uw verdeler of naar een lokaal recyclagepunt brengen.
Respecteer de plaatselijke milieuwetgeving.
Hebt u vragen, contacteer dan de plaatselijke autoriteiten inzake verwijdering.
Referencia Electrónica Embajadores: ED21300
Summary of Contents for ED21300
Page 2: ...CS300 VELLEMAN 2...
