![background image](http://html1.mh-extra.com/html/velleman/ctc1000/ctc1000_user-manual_4095568028.webp)
CTC1000
V. 04 – 11/02/2016
28
©Velleman nv
2.
Press OK to confirm.
o
The control panel starts the countdown and plays a sound.
(The sound and actual exit time depend on your settings, see 7.9.)
o
When the countdown time is up, the system will play a long sound and the system will be armed.
Arming with door opened
•
While you arm the system, if any door was detected to be open, the control panel will also sound a warning
to indicate arming is prohibited. The message Fault DSP is displayed in the middle of the top display row
and alternates at 2-second intervals with the sensor name that is being triggered.
•
At this moment, you can close the opened door, after which the error display will be cleared automatically
and the screen returns to Alarm off. You can the arm the system.
•
If you want to put the system into Arm mode with the door opened, you can use Forced Arming.
Notes
•
The Fault DSP screen has a time-out for 5 minutes. It will automatically exit and return to Alarm Off screen
after 5 minutes.
•
If a sensor is by-passed (see section Partial Arm mode), the condition of that sensor will not be checked.
•
If a sensor tampered or out-of-order occurs, you can temporarily by-pass it or permanently remove it.
11.4
Disarming the system
You can disarm the system if it is either in Away Arm mode or Home Arm mode (Alarm ON):
1.
Enter your pin code and press OK. The control panel will sound 2 short beeps and return to disarmed mode.
Remote control
•
When the system is in Home mode (see below), pressing the Disarm button on the remote control will
disarm the system.
•
When the system is in Away Arm mode, pressing the Disarm button on the remote control can disarm the
system when either an Entry device has been triggered, or when the Remote Controller Entry Enable has
been set to ON (see section
RC Ent E (= remote controller entry enabled)
in chapter 8).
11.5
Home Arm mode
The Home mode allows the home to be armed so that no one can get inside without first disarming the system,
yet the person already inside the house can move freely without triggering the alarm.
You can only enter the Home Arm mode when the system is disarmed.
To activate Home mode:
1.
Enter your pin code and press OK.
2.
Press
key to move the cursor down to select Home Arm and press OK.