CAMSETW16
00 (12/08/2008)
5
8.
Mounting
•
The camera can be mounted against the wall or the ceiling or simply placed on a desktop
using the universal bracket (
5
).
Note:
the hood (
2
) can be removed by sliding it forward. To remount, start at the rear end
of the camera and slide forward until the holes in the hood (
2
) and camera are in line.
•
When mounted on the ceiling, the universal bracket must be place on the top of the
camera (closest to antenna (
1
)). To do this, unscrew the universal bracket (
5
) from the
housing and screw it in the opening on top of the camera.
•
The receiver should be placed horizontally antenna pointing upwards. The antenna can be
rotated to improve signal reception.
9.
Operation
•
Mount the camera in a location that needs to be monitored.
•
Apply power to the camera. Insert the jack from the adapter into the DC power jack (
8
)
of the camera.
•
When necessary (interference with other devices occurs or multiple cameras are used),
set the channel by opening the channel switch cover (
6
). There are 4 channels possible,
default channel is 1. Close the switch cover (
6
) after setting the switches.
•
Point the antenna (
16
) of the receiver upwards. The antenna can be rotated in either
direction. Do not force the antenna.
•
Connect the receiver to a monitor or TV via the video and audio output jacks (
9, 10 &
11
).
Note:
YELLOW plug = video, RED plug = audio (R), WHITE plug = audio (L)
•
Connect the DC power adapter to the DC power jack (
12
).
•
Switch the power ON/OFF switch (
15
) to the ON-position.
•
Power on the monitor or TV and select AV mode.
•
The system is capable to support 4 cameras at the same time. Select the channel via the
channel select button (
17
). The current channel is indicated in the channel display (
14
).
•
Press and hold the channel select button (
17
) for 3 seconds to go in loop mode; every
channel will be shown for 5 seconds.
•
Adjust the brightness, contrast and colour settings of the monitor or TV to get the best
display result. Changing receiver and/or antenna location might improve the image.
•
In dark environmental conditions, the built-in Infra-Red lights (
4
) will automatically
become active. In this night vision mode, the image will become monochrome (black and
white). The night vision range is limited to 7m.
•
Use of the remote control:
Channel 1
Channel 2
Channel 3
Channel 4
2,414MHz 2,432MHz 2,450MHz 2,468MHz
Remote
18. Lock/unlock key
19. Channel selectors
20. Loop key
21. Channel up/down key
Summary of Contents for CAMSETW16
Page 2: ......
