AVMOD8 NL
5
Connection with a TV with an A/V component
c) Plug the supplied adapter into the wall outlet and the DC plug in the rear panel of the receiver.
d) Put the ON/OFF switch in the ON position. The LED at the front should now be lit.
e) Put the receiver in an appropriate location and adjust the antenna so the convex side is aimed at the room where the
transmitter is located. See also p. 6 : “Orienting Devices”.
6. Installing the Remote Control Function
This product allows you to operate A/V systems via your existing remote control. The IR signal of your remote is converted
into an RF signal that is transmitted to the receiver. Here the RF signal is converted into the original IR signal again and it is
used to operate the A/V source via the IR mouse.
Connect the mouse with the jack on the side of the transmitter and aim it at the IR sensor of the A/V source. Make sure
there is a direct line of sight between your remote and the IR window of the receiver. Aim the remote control at the front of
the receiver and operate it like you always do.
VHF
UHF
receiver
A/V
component
VIDEO AUDIO
RF
OUT
TV
A/V source
IR-mouse
transmitter
receiver
remote control
TV
