AVMOD17
2
NL
Content
•
1 transmitter
•
1 receiver
•
1 IR eye
•
2 A/V cables (mini-RCA or mini-SCART)
•
2 power adapters
•
1 manual
Remark : The transmitter and the receiver look very much alike. The words "transmitter" and "receiver" are printed on
top of the units to avoid all confusion.
Product Layout
Transmitter/Receiver (fig. 2)
1. Power indicator / IR window
2. IR antenna
3. ON/OFF button
4. Power adapter plug
5. Channel selector (slide the switch to the desired channel number.
Remark
: select the same channel on
transmitter and receiver!)
6. A/V jack
7. Plug for IR eye
Installation
Before connecting the
AVMOD17
:
•
Set the channel switches at the back of the transmitter and the receiver to the same channel
•
The connection method will be defined by your TV and the A/V component you're going to use (VCR, DVD player,
etc). Read the manual of that device carefully and then connect the
AVMOD17
according to the guidelines below :
1. Installing the Transmitter
1.1. Connecting the Transmitter with an A/V Device
A/V connection
Connect the mini plug of the provided A/V cables with the A/V jack at the back of the transmitter and insert the plugs
at the other end in the VIDEO, AUDIO & OUT jacks (or SCART connector "OUT") at the back of the A/V device
(marked LINE OUT). See figure 3.
RF connection – for an A/V component without additional A/V output jacks
If your A/V device is equipped with only 1 set of A/V output jacks and you want to connect it with your TV, then you
should connect the OUT connection of the A/V device and the VHF/UHF connection of the TV via a coaxial cable. If
you also want to watch cable on that TV, you should connect the input source of your cable TV with the IN
connection of the A/V device. See also fig. 4.