Selecting Audio through Built-in Speaker
/ 3.5mm AUX out
1. When the unit is turned on, press the
MENU (VOL KNOB)
to enter menu mode.
Rotate the
VOL KNOB
and scroll to 'Speaker Setting', select and confirm by
pressing
MENU
again. Select Built-in Speaker and confirm by pressing the
MENU
. Wait for the time out to return to the source you were previously on.
A speaker/volume icon “ “ will be displayed at the top of the display.
the audio will comes from the built-in 1W speaker.
2. Or connect the supplied 3.5mm Audio Cable to the 3.5mm Line Out connector
on the side of the DAB+ receiver and then connect to the Aux in of the car stereo.
Note: In 'Built-in Speaker' mode, there will be no FM transmission to the car stereo.
27
Selecting Audio Output FM transmission
Select FM transmitting Frequency:
1. Press the
MENU
button to enter menu mode. Use the Tuning Knob and scroll
to 'Speaker Setting', Select and confirm by pressing
MENU
again. Use the
Tuning Knob to select '
FM Transmit
' and confirm by pressing the
MENU
button.
This will enable FM transmission mode.
2. Use the Tuning Knob to select Transmit Frequency, rotate the Tuning Knob to
select a vacant FM transmitting frequency, each step is 0.05MHz. Wait the time
out to return to the previous status. The selected vacant frequency will be shown
at the top right of the display, e.g. TX 108.0MHz.
3. Tune your car FM radio system to match the selected vacant frequency for
transmission of the audio signal from DAB+ receiver to your car stereo audio
system.