8.5
General On Switch
Installation manual
Pag. 22 of 26
rev 06
In order to manage the unit via the control panel, this
must be connected to the conditioner
If a general switch is installed on the power line, this
must
also be switched on.
- Turn the device on by activating the generalswitch
8.6
Activation
To activate the device
The adjustment range is from 16 to 31°C in intervals
of 0.5°C.
The controller is very precise - set it to the required value an
wait for the controller to regulate itself according to the actual
room temperature detected.
8.9
Temperature selection
8.8
Stand By
8.7
Heating/cooling operation modes setting
E
Key
Operation
Display
Press the ON Stand-by key
From off to on
Select one of the 4 operating modes by pressing the relative key.
Key
Operation
Display
Keep the Heating / Cooling key pressed for approx. 2 seconds to change the
mode between heating and cooling, which is indicated by the 2 symbols that
appear if heating or cooling is active.
When heating, the symbol displays when the set point is higher than ambient
temperature, both are off when the set point is lower.
Whencooling, thesymboldisplayswhenthesetpointislowerthanambient
temperature, both are off when the set point is higher.
Key
Operation
Display
Press and hold the ON Stand-By key for approx. 2 seconds. No illuminated
signals on the display at all means that the system is in stand-by (no operation). Off
Key
Operation
Display
Set the required room temperature using the two increase/decrease keys to set
the temperature value on the 3-digit display.
20.
5
