background image

9

16

1.2.6. nECk support VELA sW ChAir

The height and position of the neck support (optional) are adjust-
able. By loosening all screws, the neck support can be positioned as 
desired. Remember to tighend again. The neck support can also be 
angled. 

1.2.7. sEAt DEpth stAnDArD

The seat depth can be adjusted by loosing the screws below the 
seat. Then you can adjust the seat. When the seat depth is ad-
justed, remember to tightend the screws again. 

1.2.8. sEAt DEpth VELA sW

The seat depth can be adjusted by shifting the back rest backwards 
or forwards in the two C-tracks: 
Loosen the two screws on both sides from the back rest hinge and 
release the sliding lever for the back angle. 

After this, the back rest can be shifted forwards or backwards. 

iMportAnt!

Make sure all the bolts are tightened after adjustment.

1.2.9. ELECtriC tiLt 

Depending on the power chair’s equipment, the following are 

selected: Fixed seat angle or electric seat angle.

Fixed seat angle can be adapted by adjusting the brace supporting 
plate. (Call a service technician).

2.0 WArnings

In consideration of your safety, the following should always be complied with:

  VELA Blues 1100 is intended for limited outdoor operation. Driving should take place on level 

and solid surfaces in places one is well familiar with.

  VELA Blues 1100 is as standard not approved as a passenger seat during car, bus or train

 transportation.

•  

The chair is not designed to be lifted during transport.

  Always make sure that the wheelchair is responsibly secure in approved lashing equipment 

 during transportation in car, bus, train or similar.

  Never stand on the footplates whilst getting on and off since this will make the wheelchair tip 

over.

  Always lower the electric lift to the lowest position before accelerating over difference in levels 

and before driving at high speed.

  Always lower the electric lift to the lowest position before driving on slanting surfaces.

  Never drive sideways on slanting surfaces as the inclination could cause the chair to overturn.

  The power chair may not be exposed to rain or heavy moisture, as water will damage the electron-

ics.

  Never cover the battery charger during charging as it develops heat. The battery charger must be 

placed on a solid surface with air circulation.

  When driving backwards as well as when operating electric functions, it must be ensured that 

this can be done without danger to other persons.

•   The 

power chair can be configured for use as a passenger seat during transport, but only as a 

specially configured version (see item 6 re. transport)

Warning!

 The VELA Blues 1100 is not as stanard approved as a passenger seat for use in cars, 

buses or trains. 
The chair is not designed to be lifted during transport.

Summary of Contents for Blues 1100













Reviews: