Sensor MD-L-*-RSA configuration
IP65
When the Veko Advanced Relay sensor is plugged into the light-line and connected to power, it will fully function and perform as a motion
detection sensor. All Veko sensors have a standard configuration. Some of these features are manual adjustable with a remote control (TR67).
These functions are described in the manual below. You can use this manual on site when a re-configuration is needed, a maintenance test is
required, or the lights need to be manually overruled.
1 Switch off delay*
The duration of switch
on after detection can
be set between 1 and
max. 99 minutes.
2 Sensitivity detection*
The sensitivity of the
movement detection can
be adjusted according to
your preferences.
3 Sensitivity twilight
mode*
The sensitivity of switch-
on relative to the
available
daylight can
be adjusted.
4 Sensitivity twilight mode
off*
Switch off twilight mode.
Note
: standard/factory
setting is: off.
5 Check the programmed
setting of:*
5.1 Time frame
light on
5.2 Detection accuracy
5.3 Sensitivity
twilight
mode
7 Test functions
The lights will flash on
and off for 10 sec.
6 Overrule function
Overrule all current
settings and switched
all lighting on or off
for a set amount of
hours.
Hold until
light responds
Hold until light responds
1x
Fast
Blink
Fast
Blink
Fast
Blink
Fast
Blink
Fast
Blink
Fast
Blink
Fast
Blink
Fast
Blink
Slow
Blink
3x Flash
Solid
Solid
Solid
Solid
3 flashes / colour
3 flashes / colour
3 flashes / colour
3 flashes / Colour
1x
1x
1x
1x
1x
1x
1x
1x
1x
1 = 1 minute
9 = 9 minutes
21 = 21 minutes
3 digits = cancel
1= Low sensitivity
...
5= High sensitivity
1= 100 Lux
...
9= 900 Lux
Flashes blue colour X times for set duration.
Long blink for first digit and short blink for second digit.
Flashes red colour X times for set Lux level.
Flashes 3x red / blue colour when twilight mode is switched off.
Flashes green colour X times for set detection
sensitivitiy.
1 = 1 hour
...
9 = 9 hours
Return to normal
Return to normal mode
Overrule is turned off / canceled
Solid
Solid
Save
Return to normal
* Automatically returns to normal mode, if there is no activity for 20 seconds. Settings will be saved.
Save
Save
Save
Cancel
Cancel
Cancel
Hold until
light responds
Hold until
light responds
Hold until
light responds
Hold until
light
responds
Hold until
light
responds
Hold until light responds
Lighting switched ON
for x hours
Lighting switched OFF
for x hours
1x
Hold until
light responds
Blink
8 Factory settings
Set back all functions
to factory settings
11/16
Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Sensor configuration
