Veigel S00280220, Installation And Operating Instructions Manual

Page: 18 / 28

5-5
Assembly
Figure 5.7: Angle bracket 2
Figure 5.6: Angle bracket
Figure 5.5: Punch-marking
Screw the centre punch into the
threaded hole for the vehicle seat.
Bend an angle bracket and position
it over the centre punch.
Use a hammer to punch-mark the
bracket.
Customising the angle brackets
Customise each angle bracket
individually.
Use the hole pattern in the vehicle
as a guide.
Create angle brackets that are of
a height whereby the installation
frame protrudes above the door
sill trim and is aligned in parallel.
Ø10.5
Ø10.5
Figure 5.8: Spacer tube
Make spacers out of the tube
provided to compensate for the
height at the vehicle seat.