5-2
Assembly
LFG5 electrical connections
Disconnect the contact housing (coming from the motor control device) from the
original accelerator pedal module.
Crimp the accelerator module connections on with the matching original contact
housing (vehicle-specific).
When laying the cable, make sure that it does not rub against sharp edges
or become pinched.
Crimp the motor control device connection on with the matching original mating
connector on the contact housing that you disconnected previously.
ATTENTION!
Fig. 5-1: VAS safety electronics
ACC1 = original accelerator pedal module
ACC2 = additional accelerator pedal module
ECU = original accelerator pedal connector
PWR = power supply/button (ig/earth -)