29
6 Setup
VEGAMIP R61 • Receiving unit
35786-EN-171120
6 Setup
6.1 Adjustment elements
The figures in brackets refer to the following illustration.
6
7
9
8
4
5
1
2
3
1
L N
3
(-)
( )
4 5 6 7 8
2
+
3 4 5 6 7 8
Fig. 23: Electronics module MP6X R (receiving unit) - Relay output
1 Mode switch for selecting the switching behaviour (min./max.)
2 Control lamp (LED) for indication of a fault (red)
3 Signal lamp (LED) for indication of the switching status (yellow)
4 Control lamp (LED) for indication of the instrument function (green)
5 Connection terminals
6 Ground terminal
7 Key for adjustment of the sensitivity and the switching delay (-->)
8 Key for adjustment of the sensitivity and the switching delay (<--)
9 LED indicating board for indication of reception strength (yellow)
There are three control lamps (LED) on the electronics module
Control lamp (red) for indication of a fault (2)
This signal lamp shows the fault status of the instrument.
Control lamp (yellow) for indication of the switching condition
(3)
The signal lamp signals the switching condition of the switching
output.
Control lamp (green) for indication of the instrument function
(4)
The green signal lamp (on) shows the operating state of the instru-
ment as soon as voltage supply is connected correctly.
With the mode switch (max./min.) you can change the switching
status of the relay. You can set the required mode according to the
"
Function table
" (max. - maximum detection or overflow protection,
min. - minimum detection or dry run protection).
Signal lamps (2, 3, 4)
Mode switch (1)
