VeEX VePAL TX300M, User Manual

Page: 371 / 421

15.7 Monitor (Pass Through)
Test Port Selection
Pass through monitor mode enables the test set to be used for long term in-service testing. This allows for bi-directional monitoring of
up to full gigabit Ethernet line rate on the two 1000Base-X ports or the two 10/100/1000T ports.
The Pass Through functionality allows:
In-line traffic monitoring in both directions
Long or short term network monitoring for troubleshooting network traffic problems
Isolate network problems to the customer network or the service provider/operator network
Monitor traffic between 1000Base-X links or 10/100/1000T links
Pass through monitor operation
Pass Through Monitor Copper 1GE
Pass Through Monitor Fiber 1GE
Pass through monitor mode enables bidirectional monitoring between the two 1000Base-X ports or the two 10/100/1000
Base-T ports
Go back to top Go back to TOC
15.7.1 Setup
The pass through monitor setup and operation is straight forward and simple:
Press the
Test Port
button on the right side of the screen and select a pass through mode option
Connect to both 1000Base-X fiber ports (port 1 and port 2) or both 10/100/1000T copper ports (port 1 and port 2), depending
on the interfaces to be monitored
Once the cable/interface connections are in place, press
Start
Monitor Mode Setup
TX300S_e-manual_D07-00-064P_RevA00