FX80 / FX81 PON Optical Power Meters User Manual
Page
33
of
50
To edit a note:
1. From the
Read
mode screen, press the
|F3| (MORE)
button and then
|F1| (NOTE)
button. The screen shown below then appears.
Editing comments to future measurement results
2. Press
|INDEX|
until the cursor in the top line starts flashing - then use
|Up|
and
|Down|
buttons to select the index number position.
3. Press
|COMMENT|
again to go to the list of symbols in the lower section. The active
symbol then gets highlighted. Use the
|Up|
and
|Down|
buttons to select another
symbol if necessary.
4. Press the
|Shift/Enter|
button to insert the selected symbol into the required position
on the top line. The comment can include up to 10 symbols in total, with 7 symbols
reserved for the comment text and 3 numbers for the comment number.
5. Press
|CLEAR|
to reset the index position to “000” when
|INDEX|
is selected or
erase the whole note when
|COMMENT|
is selected.
6. To erase a symbol in the note, place the cursor after that symbol, then select the left
arrow ) and execute the command by pressing the
|Shift/Enter|
button.
7. To save the note for the next measurement and exit the
NOTE
mode, press the
|F3|
(EXIT)
button.
To save the current measurement results with the current note:
8. Press the |
Shift/Enter| + |Up
| button combination
(Save).
The
Saved
notification is
briefly displayed onscreen, and current measurement results with the current note
are saved in the device’s memory.
Once the note is saved with measurement results, it cannot be edited.
