Veeder-Root TLS2, Upgrade Manual

Page: 8 / 13

Installation of Upgrade Kit Safety Precautions
5
Figure 3. Removing the display
983-3.eps
2 1
3
4
1 Hold the di s play and pull up the ribbon cable from it s
connector on the CPU board (item 1 in Figure 3 ) and
remove the 2-wire plug (item 2 in Figure 3 ) at the top
of the CPU board. Carefully s et the di s play a s ide.
2 Using the T-15 torx wrench, remove the ground wire
saddle clamp on the inner door (item 3
in Figure 3 ).
3 Remove the ribbon cable from its connector on the
edge of the CPU board (item 4
in Figure 3 ). Notice the
orientation of the ribbon cable in the connector as it will
connect to the new CPU board in the same way.
4 Remove and retain the top and bottom T-15 screws
and washers (item 1 in Figure 1) from the left side of
the console door. Remove and discard the door.
5 While pushing the ground wire and ribbon cable
through the slot in the inner door, remove the CPU
board/inner door assembly and discard.