TCP/IP Interface Module Installation
Installing the TCP/IP Interface Module in the Console
4
Installing the TCP/IP Interface Module in the Console
TLS-300/PROPLUS CONSOLES
1. Open the left door of the console (see Figure
2). Verify that the battery backup switch is in the On position,
then turn Off power to the console.
2. Remove knockout blank from left bottom of console. Slide in the configured TCP/IP Interface Module until the
motherboard connector is snugly seated and the left edge of the module’s bracket is in the notch cutout in the
left side of the console. Attach securing screw from kit (see Figure
3). Leave the console door open.
Figure 1. TCP/IP interface module component locations
Legend for numbered boxes in Figure
1. End plate for TLS-300/ProPlus console TCP/IP module.
2. RJ-45 Connector (typical both end plates)
3. Reset button access (typical both plates)
4. End plate for TLS-350/ProMax console TCP/IP module
5. Network connection/activity LEDs (typical both end plates)
6. J1 Connector
7. J2 Jumper - Interrupt
8. J3 Jumper - Chip Select
9. Write down the ethernet address from the label on the LTRX XPort module (in this example, 00-20-4A-82-54-CD). You
will need this address for the TCP/IP module setup.
10. Also record the rev number (in this example A11). It may be needed for the TCP/IP module setup.
