3
TCP/IP Interface Module Installation
Installation of the TCP/IP Interface module consists of:
1. Verifying the module’s configuration (Complete the checklist in Appendix A at this time),
2. Installing the module in the TLS-300 console (page 4) or the TLS-350 console (page 6),
3. Performing setup of the module in the TLS (page 8), and
4. Setting up the module’s IP Address/Configuration using either Telnet (page 15) or a browser (page 23).
Verifying TCP/IP Interface Module Configuration
Key components of the TCP/IP Interface module are shown in Figure
1.
IMPORTANT! Write down the ethernet address from the label on the back of the TCP/IP
board. You will need to enter this number for the TCP/IP board’s hardware address in the
module’s IP Address/Configuration procedure later in this manual (also record the rev of the
board as it may also be needed).