3
Installing system
DJI Mavic installation
Installing the mounting stands
Follow the following images to mount the brackets that will hold your VectorSave™ Mavic
system in place on top of you Mavic quadcopter. The brackets are equipped with special
glue pads that will safely hold then in place. You need to degrease the area where mounts
will be attached on your Mavic drone. We use ”bräkleen” by CRC but any degreasers like
isopropanol will work fine. There may be strong degrease agents that we have not tested
that may harm the surface of your Mavic - pls test with small area first if any doubt.
Remove protective cover from bracket stand and place it firmly in its wanted position.
Summary of Contents for 10 Mavic
Page 14: ...Opposite corner pairs are then laid out on the table and folded inside one after another ...
Page 15: ...Lines will be positioned to loop inside along centerline while shock cord is left outside ...
Page 16: ...Roll in the outer sides and then make a Z fold ...
Page 19: ...Here you see how everything should look with the chute half way in and cap closed ...
