6
Radio remote trigger
(RadioSave™)
General about the RadioSave™ remote trigger
If you bought the version of VectorSave™ with RadioSave™ you received a remote radio
unit that can be used to deploy parachute manually.
Charging the RadioSave™ remote
Charge RadioSave™ remote unit before use for 2 hours via USB cable to ensure it is fully
charged. Light goes on when you connect it with USB cable to indicate it is charging.
Using the RadioSave™ remote
RadioSave™ remote has range of 2 km in open air. Button is made so that it requires hard
pressure to activate. This is protecting you from mistakenly pressing the button.
Button functions are here:
1. Turn on unit by pressing the button once
2. When light is on and you press the button your parachute will be deployed if your
VectorSave™ 10 launcher has blinking blue light indicating it is armed.
3. To turn off the RadioSave™ remote unit power just keep the button pressed until the
light goes off.
Summary of Contents for 10 Mavic
Page 14: ...Opposite corner pairs are then laid out on the table and folded inside one after another ...
Page 15: ...Lines will be positioned to loop inside along centerline while shock cord is left outside ...
Page 16: ...Roll in the outer sides and then make a Z fold ...
Page 19: ...Here you see how everything should look with the chute half way in and cap closed ...
