6
4. Rubberized handle
5. Rubberized base
6. Rubberized bezel
7. Tools — (Hammer, Phillips screwdriver, Flathead screwdriver, Hex-
key set,
Adjustable wrench and Slip-joint pliers)
8. Reflector panel
9. Red LED flashing hazard light 12 volt power cord, with
10. 10 amp overload protection (Fuse located inside barrel)
5. REPLACEMENT PARTS
For replacement parts (bulbs, cords, fuses, etc.), contact Vector
Customer Service: (954) 584-4446 or toll-free (866) 584-5504.
5.1 HALOGEN SPOTLIGHT REPLACEMENT
• Pull rubberized bezel off spotlight.
• Unscrew the protective ring (2 small screws, Phillips
screwdriver needed.)
• Remove the lens carefully.
• Remove the rubber insulator.
• Remove the halogen bulb, by pushing 2 small wires together
and pull gently.
• Replace the bulb, make sure it is secure.
• Replace the protective ring and carefully tighten small screws.
Do not over tighten!
• Push the black rubberized bezel back into place.
5.2 FUSE REPLACEMENT DIAGRAM
6. SPECIFICATIONS
MODEL
VEC271MG Portable 1,000,000 Candle Power Spotlight and Tool Kit
BULB
H3, 55 watt
POWER CORD
Use with 12 volt DC vehicle accessory outlet
HEIGHT
8.5 in (21.6 cm)
LENGTH
15.5 in (39.4 cm)
MAKE SURE FUSE IS REPLACED WITH SAME TYPE AND AMP
RATING. ELECTRIC SHOCK COULD RESULT IF DIRECTIONS ARE
NOT FOLLOWED.