background image

3

1. SAFETY INFORMATION AND INSTRUCTIONS

The following symbols will be used throughout this manual.

The following safety precautions must be followed at all times along
with any additional existing safety rules.

1. Completely read this product manual as well as all manufacturers’
user manuals prior to usage of unit and/or tools.

2. Be thoroughly familiar with the proper use of the unit and/or tools.

3. Always plug 12 volt DC power cord into 12 volt DC accessory
power outlet only.

4. Never operate the unit near fire, flammable gas or liquid.

5. Never leave unit unattended while in use.

6. Never submerge this unit in water. When using the unit near water,
do not allow electrical cord to become damp, moist or wet as electrical
shock could result.  Always protect the unit from rain, snow or other
sources of moisture. 

7. Keep unit and/or tools out of reach of children and untrained
people (whether stored, or in use)!

8. All ON/OFF switches must be in the OFF position when the unit is
not in use. Make sure all switches are in the OFF position before
connection to a power source or load. 

9. When using this unit, stand the unit on a flat, stable surface, and
be sure to keep all clamps, cords, clothing and body parts away from
moving components.

10. Hand tools must be used for proper application. 

11. Proper protective eyewear (safety goggles) must be worn when
using hand tools. Tools may chip if struck with other objects of equal
hardness and could cause bodily injury if not used with extreme care.

12. Check unit periodically for wear and tear. Replace worn or
defective parts immediately. Contact Vector Customer Service at (954)
584-4446 or toll-free (866) 584-5504.

INDICATES AN IMMINENTLY HAZARDOUS SITUATION WHICH, IF
NOT AVOIDED, WILL RESULT IN DEATH OR SERIOUS INJURY.

INDICATES A POTENTIALLY HAZARDOUS SITUATION WHICH, IF
NOT AVOIDED, COULD RESULT IN DEATH OR SERIOUS INJURY.

INDICATES A HAZARDOUS SITUATION WHICH, IF NOT AVOIDED, MAY
RESULT IN MINOR OR MODERATE INJURY.

INDICATES IMPORTANT INFORMATION THAT IF NOT FOLLOWED, MAY CAUSE
DAMAGE TO EQUIPMENT.

Summary of Contents for VEC271MG









Reviews: