background image

2

SAVE THESE  INSTRUCTIONS

NOTE: This unit is shipped in a partially charged state. Initial charge time is approximately

18-20 hours, 15 hours thereafter

.

IMPORTANT SAFETY INSTRUCTIONS

WARNINGS: 

Contains non-spillable, sealed, lead-acid battery. Battery must be recycled or dis-

posed of properly. For battery disposal information call toll-free (877) 288-7722. 

DO NOT 

dispose of batteries in fire, as this may result in an explosion.

DO NOT 

open battery or short circuit, as this may cause the bat-

tery to leak or get hot, causing personal injury. 

Please read Instruction Manual completely for all safety and warning instructions.

WARNINGS:  USE ONLY WITH CHARGER PROVIDED WITH UNIT.

DURING AC RECHARGE OR DC RECHARGE:

a) Never turn on while charging.

b) After recharge – disconnect cord and wait 5 minutes before use.

DO NOT OVERCHARGE:

a) AC recharge 15 hours.

b) DC recharge 5 hours maximum.

1. Do not substitute power cords or adapters. Only recharge with supplied AC

and DC recharge adapters. Recharge adapters for this unit supply 12 volts

DC. Do not recharge with adapters other than the ones supplied with this unit.

2.  Do not submerge in water. This unit is not waterproof - it is weather resistant.
3.  Do not overcharge battery.
4.  Do not operate spotlight while recharging. This will prevent battery recharge

and overheat the charging adapters.

5.  Lens gets very hot when spotlight is operating. Do not touch lens - keep chil-

dren away from spotlight. This is not a toy!

6.  Keep combustibles away from spotlight lens - extreme heat can cause fires. 
7.  Keep sharp objects away from glass lens - it is breakable.
8.  Do not drop or throw spotlight, it contains glass and a sealed lead acid bat-

tery.

9.  Dispose of unusable batteries in a responsible manner (see battery disposal

section).

10. Make sure that during recharge, cords are protected from damage.
11. Do not crush, cut, pull or expose recharge adapter cords to extreme heat.
12. Keep recharge cords away from sharp edges. Position recharge cords so that

they do not become entangled or become a safety hazard.

1. INTRODUCTION

Congratulations on purchasing the Vector 2,000,000 Power Series Spotlight, an

advanced design combination spotlight and area light. It instantly converts use from a

powerful spotlight to a soft, long-lasting area light. It uses a powerful, proven-technol-

ogy, rechargeable, non-spillable, sealed, lead-acid battery that allows for years of

dependable use, recharge after recharge. The spotlight was designed from the ground

up to be the most versatile and practical light for travel, camping, picnicking, tailgate

parties and boating. This spotlight gives you the kind of light you need, when and

where you need it.

Summary of Contents for VEC184POB








Reviews: